EasyManua.ls Logo

Truma Mover XT4 - Remote control symbols and acoustic signals

Truma Mover XT4
96 pages
Go to English
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
30
60020-00216 ∙ 00 ∙ 08/2022
Product description Mover XT4
EN
system comes to an imediate standstill for safety re-
asons if radio frequency interference occurs� It is im-
possible for other radio signals to set the manoeuvring
system in motion�
Fig. 6
ON / OFF
Switch on / switch off (slide switch on the
side)
SLIDE CONTROL
Drive forward and in reverse
CONTROL KNOB
Drive to the left (in an anti-clockwise di-
rection) and to the right (in a clockwise
direction)
ENGAGE
Drive rollers engaged
DISENGAGE
Drive rollers disengaged
4.5.2 The remote control’s symbols and acoustic
signals
Symbol Colour Meaning
Red Warning – power supply / Mover
battery’s charging status
Yellow Short-term malfunction or
warning
Red Continuous fault
Green Radio connection status
Sym-
bol
Display Meaning
Switch on and normal operation
Sym-
bol
Display Meaning
Flashes slowly Once the remote control
is switched on, the radio
connection is established
(this takes approx� 5 se-
conds)� Wait until the data
link is stable
Lights up
continuously
Remote control and con-
trol unit are ready for ope-
ration, data link stable
Flashes rapidly
with acoustic
signals
If a data link has not been
established after 10 se-
conds, the remote control
switches off� The control
unit may not be switched
on, or the 13-pole plug
may not be plugged into
the safety socket
Flashes slowly During engagement and
disengagement, 1 acou-
stic signal indicates the
start of the process, and 2
acoustic signals indicate
the end of the process
Flashing with
acoustic signals
Radio connection was in-
terrupted� Reduce the dis-
tance between the remote
control and caravan (or
remedy the malfunction)
and switch the remote
control back on again�
Switch on, special process
Lights up
Flashes with
acoustic signal
The last engagement or
disengagement was not
completed:
Operation is only possible
when engagement or di-
sengagement is repeated�
Activate engagement or
disengagement and wait
until it is complete�
Sym-
bol
Display Meaning
No button is pressed on the remote control for some
time
Flashes rapidly
with acoustic
signals
The remote control swit-
ches off

Table of Contents

Other manuals for Truma Mover XT4

Related product manuals