Truma Mover XT4 - Page 31

60020-00216 ∙ 00 ∙ 08/2022
Product descriptionMover XT4
31EN
Sym-
bol
Display Meaning
Rapid flashing
with acoustic
signals
The remote control is swit-
ched off after a while� The
warning symbol means
that the drive rollers are
still engaged
Sym-
bol
Display Meaning
Switch off, usual process
Goes out The remote control was
switched off while the
control unit was still in
operation and the drive
rollers were disengaged�
Afterwards, the control
unit should be switched
off and the 13-pole safety
plug should be pulled out�
Switch off, special process
Flashes with
acoustic signal
Warning that the drive
rollers are still engaged
while the remote control is
switching off� The remote
control switches off after
a short time� Switch the
remote control back on
again, disengage the drive
rollers and switch off the
remote control again�
Lights up
Flashes with
acoustic signal
The control unit was swit-
ched off while the remote
control was switched on�
The drive rollers were di-
sengaged during this pro-
cess� The remote control
switches off after a short
time� Move the remote
control’s slide switch into
the Off position�
Lights up
Flashing with
acoustic signal
The control unit was swit-
ched off while the remote
control was switched on�
Warning: The drive rollers
were engaged during this
process�
The remote control swit-
ches off after a while�
Switch the control unit
and the remote control
back on again, disenga-
ge the drive rollers and
switch off normally�
Sym-
bol
Display Meaning
Flashing with
acoustic signal
The 13-pole safety plug
was pulled out while the
remote control was swit-
ched on�
Warning: The drive rollers
were engaged during this
process�
Switch the control unit
back on again by plugging
in the safety plug, switch
the remote control off and
back on again, disenga-
ge the drive rollers and
switch off normally�
Flashes with
acoustic signals
The 13-pole safety plug
was pulled out while the
remote control was swit-
ched on�
The drive rollers were di-
sengaged during this pro-
cess� The remote control
switches off after a short
time� Move the remote
control’s slide switch into
the OFF position�
Sym-
bol
Display Meaning
What to do if the battery is weak or if overcurrent /
overtemperature / other malfunctions occur
Lights up lights up in the event of
a temporary malfunction,
and an acoustic signal is
also emitted in the event
of overcurrent / overtem-
perature� The power is au-
tomatically reduced� Allow
the system to cool down�
Light up if sym-
bols appear
The battery charge is low,
the remote control swit-
ches off after one minute
with acoustic signals�
Charge the battery, re-
place it if necessary after
checking it
Lights up con-
tinuously with
acoustic signal
lights up in the event of
a persistent fault, and an
acoustic signal is also
emitted, e�g� in the event
of a faulty drive motor,
engage the parking bra-
ke� See the Malfunctions
chapter
XT-Reihe
All symbols “off” and no acoustic signal