TSC DA200 Series Service Manual

DA200/ DA300
Bar Code Printer Service Manual
13
3.3 Replacing the Main Board Assembly
1. Remove 4 screws on the
printer lower cover.
2. Disconnect all connectors on
the main board.
3. Remove 2 screws to replace
the main board assembly. If
you have optional multi
interface board assembly,
remove 4 screws to replace it.
4. Reassemble the parts in the
reverse procedure.
Main board
ass’y
Optional
multi
interface
ass’y

TSC DA200 Series Specifications

General

Resolution	203 dpi
Max Print Width	108 mm (4.25")
Max Print Length	2, 794 mm (110")
Processor	32-bit RISC CPU
Media Roll Diameter	127 mm (5") OD
Ribbon Core Diameter	25.4 mm (1")
Print Method	Thermal Transfer/Direct Thermal
Max Print Speed	6 ips (inches per second)
Memory	8 MB Flash, 8 MB SDRAM
Interface	USB 2.0
Media Sensor	Reflective, Transmissive
Media Handling	die-cut, fan-fold, continuous
Media Type	Gap, Black mark, Notch, Continuous
Media Width	20 mm ~ 112 mm (0.79" ~ 4.41")
Media Thickness	0.06 mm ~ 0.19 mm
Ribbon Width	30 to 104 mm
Ribbon Length	300 m (984 feet)
Power Supply	External universal switching power supply