TSC DA200 Series Service Manual

DA200/ DA300
Bar Code Printer Service Manual
35
4. TROUBLESHOOTING
The following guide lists the most common problems that might be encountered when
operating this bar code printer. If the printer still does not function after all suggested
solutions have been invoked, please contact the Customer Service Department of your
purchased reseller or distributor for assistance.
4.1 LED Status
This section lists the common problems that according to the LED status and other
problems you may encounter when operating the printer. Also, it provides solutions.
LED Status
/ Color
Printer
Status
Possible Cause
Recovery Procedure
OFF
No response
No power
* Turn on the power switch.
* Check if the green LED is lit on power supply. If
it is not lit on, power supply is broken.
* Check both power connections from the power
cord to the power supply and from the power
supply to the printer power jack if they are
connected securely.
Solid Green
ON
The printer is ready to
use.
* No action necessary.
Green with
blinking
Pause
The printer is paused.
* Press the FEED button to resume for printing.
Red with
blinking
Error
The out of label or the
printer setting is not
correct
* Printer setting is not correct
* Initialize the printer by instructions in “Power on
Utility” or “Diagnostic Tool”.
Note:
Printer status can be easily shown on the Diagnostic Tool. For more information about the
Diagnostic Tool, please refer to the instruction in the software CD disk.

TSC DA200 Series Specifications

General

Brand	TSC
Model	DA200 Series
Category	Printer
Language	English