EasyManua.ls Logo

TSC DA200 Series

TSC DA200 Series
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DA200/ DA300
Bar Code Printer Service Manual
27
5. Connect the cutter module
harness connector to the
8-pin white socket on the
printer main board.
6. Place the cutter module into the both sides of notches on lower inner printer.
Then push the cutter module to lock into the lower front printer. (see picture
below)

Other manuals for TSC DA200 Series

Related product manuals