TSC ME240 Service Manual

30
30
3.14 Peel-off Module Installation (Option)
1. Open printer right side cover.
2. Remove one screw to remove the lower front cover.
3. Thread the peel-off module cable through the bottom of lower print mechanism.
4. Plug the peel-off module mini DIN cable connector into the cutter/peel-off connector. The
arrow mark on the connector must be at the upper side.
Lower print
mechanism
Lower front
cover
Peel-off module cable
Screw
Arrow mark
Peel/cutter
module cable
connector

TSC ME240 Specifications

General

Resolution	203 dpi / 300 dpi
Operating Temperature	5°C to 40°C (41°F to 104°F)
Print Method	Thermal Transfer & Direct Thermal
Interface	USB
Power Supply	AC 100-240V, 50/60Hz
Humidity	20% to 85% RH (non-condensing)