TSC ME240 Service Manual

26
26
3.12 Centronics Parallel Interface Board Installation (Option)
1. Refer to section 3.1 to remove the electronics
cover.
2. Remove two screws to remove the interface
cover.
3. Use two screws to fix the Centronics parallel
interface board on the rear of printer.
4. Break the tab at the interface cover to get the
parallel interface opening. Then fasten the
interface cover back by two screws.
Screws
Screws

TSC ME240 Specifications

General

Resolution	203 dpi / 300 dpi
Operating Temperature	5°C to 40°C (41°F to 104°F)
Print Method	Thermal Transfer & Direct Thermal
Interface	USB
Power Supply	AC 100-240V, 50/60Hz
Humidity	20% to 85% RH (non-condensing)