To Next Page

To Previous Page

3.8 Loading Label in Cutter Mode (Option)

1. Please refer to section 3.3 to load the media.

Lead the media through the cutter paper opening.

2. Close the printer cover.

3. Use software or LCD menu function to set the

media sensor type and calibrate the selected

sensor. (refer to chpter 4 & 5)

4. Use software or LCD menu function to enable the

cutter mode.

5. Press the FEED button to test.

Questions and Answers:

Need help?

Do you have a question about the TSC PRINTRONIX AUTO ID TC200 Series and is the answer not in the manual?

TSC PRINTRONIX AUTO ID TC200 Series Specifications

General