To Next Page

To Previous Page

3. Setup

3.1 Setting up the Printer

1. Place the printer on a flat, secure surface.

2. Make sure the power switch is off.

3. Connect the printer to the computer with the provided USB cable.

4. Plug the power cord into the AC power cord socket at the rear of the printer,

and then plug the power cord into a properly grounded power outlet.Place the

printer on flat surface.

 Note: Please switch OFF the printer before plugging in the power cord to printer power jack.

Questions and Answers:

Need help?

Do you have a question about the TSC PRINTRONIX AUTO ID TC200 Series and is the answer not in the manual?

TSC PRINTRONIX AUTO ID TC200 Series Specifications

General