TSC TTP-247 User Manual

i
COPYRIGHT DECLARATION ..............................................................................1
COMPLIANCES................................................................................................1
1. Introduction.........................................................................................1
2. Getting Started....................................................................................1
2.1 Unpacking and Inspection............................................................1
2.2 Equipment Checklist.....................................................................1
2.3 Printer Parts...................................................................................3
3. Setup....................................................................................................4
3.1 Setting Up the Printer ...................................................................4
3.2 Loading the Ribbon.......................................................................4
3.3 Loading Label Stock.....................................................................6
3.4 External Label Roll Mount Installation (Option) .........................8
3.5 Peel-off Module Installation (Option)...........................................9
3.5.1 Loading the Paper in Peel-off Mode....................................12
3.6 Cutter Module Installation (Option) ...........................................14
3.6.1 Loading Label in Cutter Mode .............................................17
3.7 Instructions to Top Cover Operation.........................................18
3.8 Diagnostic Tool ...........................................................................21
3.8.1 Start the Diagnostic Tool......................................................21
3.8.2 Printer Function (Calibrate sensor, Ethernet setup, RTC
setup………)...................................................................................22
3.9 Setting Ethernet by Diagnostic Utility (Option) ........................23
3.9.1 Using USB interface to setup Ethernet interface...............23
3.9.2 Using RS-232 interface to setup Ethernet interface ..........24
3.9.3 Using Ethernet interface to setup Ethernet interface........25
3.10 Install Memory Card..................................................................27
4. Power on Utilities..............................................................................29
4.1 Ribbon and Gap/Black Mark Sensor Calibration......................29
4.2 Gap/Black Mark Calibration, Self-test and Dump Mode...........29
4.3 Printer Initialization.....................................................................33
4.4 Set Black Mark Sensor as Media Sensor and Calibrate the
Black Mark Sensor............................................................................34
4.5 Set Gap Sensor as Media Sensor and Calibrate the Gap Sensor
34
4.6 Skip AUTO.BAS...........................................................................34
5. Maintenance......................................................................................36
Contents

TSC TTP-247 Specifications

General

Print Method	Thermal Transfer / Direct Thermal
Resolution	203 dpi
Max Print Width	4.09" (104 mm)
Processor	32-bit RISC CPU
Weight	2.5 kg
Max Print Speed	7 ips
Memory	8 MB SDRAM, 4 MB Flash
Interface	USB 2.0, Serial
Ribbon Capacity	300 meters
Label Width	1" (25.4 mm) ~ 4.33" (110 mm)
Label Thickness	0.06 mm ~ 0.19 mm
Power Supply	External Universal Switching Power Supply
Operating Temperature	5°C to 40°C (41°F to 104°F)
Storage Temperature	-4°F to 140°F (-20°C to 60°C)
Operating Humidity	25% to 85%, non-condensing
Certifications	CE, FCC, UL, CCC