TSC TTP-247 User Manual

26
The default IP address is obtained by DHCP. To change the setting to static
IP address, click “Static IP” radio button then enter the IP address, subnet
mask and gateway. Click “Set IP” to take effect the settings.
Users can also change the “Printer Name” by another model name in this
fields then click “Set Printer Name” to take effect this change.
Note: After clicking the “Set Printer Name” or “Set IP” button, printer
will reset to take effect the settings.
8. Click “Exit” button to exit the Ethernet interface setup and go back to
Diagnostic Tool main screen.
Factory Default button
This function will reset the IP, subnet mask, gateway parameters obtained
by DHCP and reset the printer name.
Web setup button
Except to use the Diagnostic Utility to setup the printer, you can also
explore and configure the printer settings and status or update the firmware
with the IE or Firefox web browser. This feature provides a user friendly
setup interface and the capability to manage the printer remotely over a
network.

TSC TTP-247 Specifications

General

Print Method	Thermal Transfer / Direct Thermal
Resolution	203 dpi
Max Print Width	4.09" (104 mm)
Processor	32-bit RISC CPU
Weight	2.5 kg
Max Print Speed	7 ips
Memory	8 MB SDRAM, 4 MB Flash
Interface	USB 2.0, Serial
Ribbon Capacity	300 meters
Label Width	1" (25.4 mm) ~ 4.33" (110 mm)
Label Thickness	0.06 mm ~ 0.19 mm
Power Supply	External Universal Switching Power Supply
Operating Temperature	5°C to 40°C (41°F to 104°F)
Storage Temperature	-4°F to 140°F (-20°C to 60°C)
Operating Humidity	25% to 85%, non-condensing
Certifications	CE, FCC, UL, CCC