EasyManua.ls Logo

TSC TTP-286MT Series - Replacing the Cutter Driver IC Board

TSC TTP-286MT Series
39 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
27
27
3.12 Replacing the Cutter Driver IC Board
1. Remove 2 connectors on the cutter driver IC board.
2. Remove 2 screws to remove/replace the cutter driver IC board.
3. Reassemble the parts in the reverse procedures.

Other manuals for TSC TTP-286MT Series

Related product manuals