What to do if my TSC Printer says 'No Paper'?
If your TSC Printer displays 'No Paper', the label might be installed incorrectly. Please refer to the user’s manual for instructions on how to reinstall the label roll.
How to troubleshoot if the power indicator does not illuminate on my TSC Barcode Reader?
If the power indicator on your TSC Barcode Reader does not illuminate, the power cord may not be properly connected. Plug the power cord into both the printer and the outlet, and then switch the printer on.
Why is the label feeding unstable on my TSC TTP-286MT Printer?
If your TSC Printer is not feeding labels stably and they are skewed during printing, the media guide might not be touching the edge of the media. Adjust the media guide and then lock it in place.
How do I correct the left side printout position on my TSC Barcode Reader?
To correct the left side printout position on your TSC Barcode Reader: * Ensure the correct label size is set. * Fine-tune the Shift X parameter by pressing [MENU] [SELECT] x 3 [DOWN] x 5 ? [SELECT] in the LCD menu.
Why is my TSC Barcode Reader unable to use the SD card?
If your TSC Barcode Reader can't use the SD card: * Ensure you are using a supported capacity SD card. * Try reinserting the SD card. * Use an approved SD card from SanDisk or Transcend with the following specifications: 128MB, 256MB, 512MB, 1GB, or 4GB SDHC CLASS 6.
How do I fix unstable label feeding (skew) on my TSC Barcode Reader?
To fix unstable label feeding (skew) when printing: * If the label is moving to the right, move the label guide to the left. * If the label is moving to the left, move the label guide to the right, ensuring the media guide touches the edge of the media.
How to resolve wrinkle problem on my TSC Barcode Reader?
To resolve wrinkle problems: * Make sure the label guide touches the edge of the media guide. * Ensure the label, paper core, and ribbon are set at the center of the spindle.
Why does my TSC TTP-286MT skip labels when printing?
If your TSC Printer skips labels when printing, the sensor sensitivity may not be set properly. Calibrate the sensor using the Auto Gap or Manual Gap options.
How to improve poor print quality on a TSC Printer?
If the print quality of your TSC Printer is poor, it may be due to dust or adhesive accumulation on the print head. Try cleaning the print head.
What to do if my TSC TTP-286MT has a paper jam?
If your TSC Printer has a paper jam, the labels may be stuck inside the printer mechanism. Remove any stuck labels from inside the printer.
General| Print Method | Thermal transfer / Direct thermal |
|---|---|
| Processor | 32-bit RISC |
| Max Print Speed | 5 inches per second |
| Resolution | 203 dpi |
| Memory | 8 MB Flash |
| Interface | USB, Serial, Parallel |
| Operating Temperature | 5°C to 40°C (41°F to 104°F) |
| Print Length | Up to 39 inches |
| Media Type | Labels, Tags, Tickets |
| Media Width | 0.5 to 4.5 inches |
| Media Thickness | 0.06 mm |
| Media Core Diameter | 25.4 mm (1 inch) |
To Next Page
