How to resolve wrinkle problem on my TSC Barcode Reader?
To resolve wrinkle problems: * Make sure the label guide touches the edge of the media guide. * Ensure the label, paper core, and ribbon are set at the center of the spindle.
What to do if my TSC Printer says 'No Paper'?
If your TSC Printer displays 'No Paper', the label might be installed incorrectly. Please refer to the user’s manual for instructions on how to reinstall the label roll.
How to fix a TSC TTP-286MT when the power indicator does not illuminate?
If the power indicator on your TSC Printer doesn't light up, make sure the power cord is properly connected to both the printer and the outlet, and that the printer is switched on. Also, ensure the printer carriages are closed.
What to do if my TSC TTP-286MT has a paper jam?
If your TSC Printer has a paper jam, the labels may be stuck inside the printer mechanism. Remove any stuck labels from inside the printer.
How to improve poor print quality on a TSC Printer?
If the print quality of your TSC Printer is poor, it may be due to dust or adhesive accumulation on the print head. Try cleaning the print head.
Why does my TSC TTP-286MT skip labels when printing?
If your TSC Printer skips labels when printing, the sensor sensitivity may not be set properly. Calibrate the sensor using the Auto Gap or Manual Gap options.
What to do if there is no print on the label from my TSC Printer?
If there is no print on the label from your TSC Printer, the label or ribbon might not be loaded correctly. Follow the instructions for loading the media and ribbon.
How to resolve irregular printing on my TSC TTP-286MT?
If your TSC Printer is printing irregularly, it might be in Hex Dump mode. Turn the printer off and then on again to exit the dump mode.
Why is my TSC TTP-286MT Printer missing printing on the left or right side of the label?
If your TSC Printer is missing printing on the left or right side of the label, the label size setup may be incorrect. Set the correct label size.
How to fix a gray line on the blank label from my TSC TTP-286MT Printer?
If you see a gray line on the blank label from your TSC Printer, the print head is likely dirty. Clean the print head.
General| Print Method | Thermal transfer / Direct thermal |
|---|---|
| Processor | 32-bit RISC |
| Max Print Speed | 5 inches per second |
| Resolution | 203 dpi |
| Memory | 8 MB Flash |
| Interface | USB, Serial, Parallel |
| Operating Temperature | 5°C to 40°C (41°F to 104°F) |
| Print Length | Up to 39 inches |
| Media Type | Labels, Tags, Tickets |
| Media Width | 0.5 to 4.5 inches |
| Media Thickness | 0.06 mm |
| Media Core Diameter | 25.4 mm (1 inch) |
To Next Page
