What to do if the ribbon encoder sensor doesn’t work on my TSC TTP-286MT?
If the ribbon encoder sensor on your TSC Printer isn’t working, the ribbon encoder sensor connector might be loose. Fasten the connector.
Why doesn’t the ribbon end sensor work on my TSC TTP-286MT Printer?
If the ribbon end sensor on your TSC Printer doesn’t work, the connector might be loose. Check the connector.
General| Print Method | Thermal transfer / Direct thermal |
|---|---|
| Processor | 32-bit RISC |
| Max Print Speed | 5 inches per second |
| Resolution | 203 dpi |
| Memory | 8 MB Flash |
| Interface | USB, Serial, Parallel |
| Operating Temperature | 5°C to 40°C (41°F to 104°F) |
| Print Length | Up to 39 inches |
| Media Type | Labels, Tags, Tickets |
| Media Width | 0.5 to 4.5 inches |
| Media Thickness | 0.06 mm |
| Media Core Diameter | 25.4 mm (1 inch) |
To Next Page
