TSC TTP-368MT Series - Loading Media in Cutter Mode (Option)

- 24 -
3.3.3 Loading Media in Cutter Mode (Option)
1. Open the printer right side cover.
2. Please refer to section 3.3.1 to load media.
3. Lead the media through the cutter paper
opening.
4. Adjust the label guide to fit the width of the
label.
5. Close the print head mechanism making
sure the latches are engaged properly.
6. Using the front display panel, set the
printer setting to cutter mode. Press the
FEED button to test.
Note:
Please calibrate the gap/black mark sensor
when changing media.