Why isn't the ribbon end sensor working on my TSC TTP-368MT Printer?
If the ribbon end sensor isn't working on your TSC Printer: * Check the connector. * Clear any dust in the sensor hole using a blower.
Why is my TSC TTP-368MT not printing anything on the label?
If your TSC Printer is not printing on the label, consider the following: * Ensure the label and ribbon are loaded correctly, following the loading instructions. * Verify that the ribbon and media are compatible. * Reload the ribbon, ensuring the inked side is correct. * Clean the printhead. * Check that the print density setting is correct.
How to fix poor print quality on my TSC Printer?
To resolve poor print quality on your TSC Printer: * Reload the ribbon and media. * Clean the print head and platen roller. * Adjust the print density and print speed. * Run a printer self-test to check the print head test pattern for missing dots. * Change to a proper ribbon or label media. * Adjust the printhead pressure adjustment knob.
What to do if my TSC TTP-368MT says 'No Paper'?
If your TSC Printer indicates 'No Paper', consider these solutions: * Supply a new label roll. * Reinstall the label roll, referring to the user manual for guidance. * Calibrate the gap/black mark sensor.
Why does my TSC Printer skip labels when printing?
If your TSC Printer is skipping labels, try these solutions: * Check if the label size is set up correctly. * Calibrate the sensor using Auto Gap or Manual Gap options. * Clear any dust from the GAP/Black mark sensor using a blower.
How do I resolve wrinkle problems when printing with my TSC TTP-368MT Printer?
To address wrinkle problems with your TSC Printer: * Refer to section 4.2. * Set a suitable print density for good print quality. * Ensure the label guide touches the edge of the media guide.
What does 'Carriage Open' mean on my TSC TTP-368MT?
If your TSC Printer displays 'Carriage Open', please close the print carriages.
Why is the peel sensor not working on my TSC TTP-368MT?
If the peel sensor is not working on your TSC Printer: * Ensure that the media goes through the Peel sensor. * Plug the connect cable correctly.
Why is the left side printout position incorrect on my TSC Printer?
If the left side printout position is incorrect on your TSC Printer: * Set the correct label size. * Fine-tune the Shift X parameter by pressing [MENU] [SELECT] x 3 [DOWN] x 5 [SELECT].
Why is my TSC TTP-368MT Printer printing a gray line on blank labels?
If your TSC Printer is printing a gray line on blank labels, clean the print head and the platen roller.
General| Print Technology | Thermal Transfer |
|---|---|
| Print Resolution | 203 dpi |
| Media Thickness | 0.06 mm (0.00236") ~ 0.28 mm (0.011") |
| Media Core Diameter | 25.4 mm (1") ~ 76.2 mm (3") |
| Interface | USB, Ethernet |
| Operating Temperature | 5 ~ 40°C (41 ~ 104°F) |
| Operating Humidity | 25 ~ 85% non-condensing |
| Certifications | CE, FCC |
| Label Thickness | 0.06 - 0.25 mm |
| Operating System Compatibility | Windows |
To Next Page
