TSC TTP-368MT Series - Z-Axis Mechanism Adjustment Knob

48
4.4 Z-axis Mechanism Adjustment Knob
For narrow media, If change the print head pressure adjustment knob setting can’t get the
printout without ribbon wrinkle, the Z-axis mechanism adjustment knob should be adjusted
to get the satisfied printout. This Z-axis mechanism adjustment knob is used to fine tune the
right side pressure of print head. Before fine tune the print head right side pressure, please
set the pressure adjustment knob to index “1” then use use the Z-axis adjustment knob to
fine tune the right side print head pressure. Please refer to the adjustment steps as below.
1. Loosen the fixing nut to the top of knob. (Move the nut only.)
Factory default
Loosen the nut to the top
Z-axis mechanism
adjustment knob
Fixing nut
Indicator (The default
position is set at the lowest
line.)