6 DAILY MAINTENANCE
Step 6: Clean the Oven Interior
t4QSBZ5VSCP$IFG¥0WFO$MFBOFSPOUPUIFUPQCPUUPNBOETJEFTPGPWFOJOUFSJPS
CAUTION: DO NOT spray Oven Cleaner into the holes on the back oven
wall. Doing so can damage critical oven components, resulting in a non-
warranty service call.
t"MMPX0WFO$MFBOFSUPQFOFUSBUFTUBJOTGPSGJWFNJOVUFT
t$MFBOUIFPWFOJOUFSJPSXJUIBOZMPOTDSVCQBE
CAUTION: DO NOT attempt to scrub the upper jetplate (Fig B). If food is
stuck to the oven ceiling, gently remove it without applying pressure to the
ceramic plate. Breakage will result in a non-warranty service call.
CAUTION: DO NOT remove the top ceramic jetplate (A); breakage will result
in a non-warranty service call.
Step 7: Clean and Dry the Oven Door
t$MFBOUIFPWFOEPPSXJUI0WFO$MFBOFSBOEBOZMPOTDSVCQBE
t8JQFUIFPWFOEPPSXJUIBEBNQUPXFMBOEUIFOBESZUPXFM
Step 8: Rinse or Wipe the Oven Interior
CAUTION: DO NOT use a hose or water jet for cleaning. Doing so can damage
critical oven components, resulting in a non-warranty service call.
t8JQFEPXOUIFPWFOJOUFSJPSXJUIBDMFBOEBNQUPXFM
t%SZUIFPWFOJOUFSJPSXJUIBDMFBOUPXFM
Step 9: Apply TurboChef® Oven Guard - Optional for Easier Maintenance
t4QSBZ5VSCP$IFG¥0WFO(VBSEPOUPBDMFBOUPXFM
t8JQFUIFJOUFSJPSXBMMTBOEUIFJOTJEFPGUIFPWFOEPPS
CAUTION: DO NOT spray Oven Guard into the cavity, especially around the
holes on the back oven wall. Doing so can damage critical oven components,
resulting in a non-warranty service call.
Step 10: Reinstall Components
t3FDPOOFDUUIFXJSFSBDLUPUIFMPXFSKFUQMBUFBOESFJOTUBMMCPUIJUFNT
t$MPTFUIFPWFOEPPS
t3FJOTUBMMUIFGJMUFSPSSFQMBDFJUXJUIBOFXPOFJGUIFNFTIJTEFUFSJPSBUFEIBT
large openings, or has started to dislodge from the frame.
Step 11: Clean the Oven Exterior
t8JQFUIFPWFOFYUFSJPSXJUIBDMFBOEBNQUPXFM
t3FNPWFUIFMPXFSQBOFMBOESFNPWFMBSHFGPPEQBSUJDMFT
t8JQFUIFQBOFMXJUIBDMFBOEBNQUPXFM
CAUTION: DO NOT spray chemicals into any openings, such as the louvers on
the side panels or the rear vent catalyst housing. Doing so can damage critical
oven components, resulting in a non-warranty service call.
t5IFPWFOJTSFBEZUPUVSOPO
Upper
jetplate
Step 6 (Fig B)
Step 7
Step 8
Step 9
Step 10
Step 11
Step 6 (Fig A)