8 OVEN CONTROLS AND COOKING
Step 3: Warming Up
During this step, the oven warms to the selected or pre-set
temperature.
Step 2: Select Cook Temperature
The oven stores two different cook temperature settings (see
page 17 for more information). Only items associated with
the selected temperature setting can be cooked without
re-specifying the temperature setting.
To select a temperature, press the adjacent soft key.
NOTE: If both temperature settings are the same, this screen will be bypassed and access to all food items will
be allowed.
Step 1: Turn the Oven On
When the oven is off (Figure 5), the oven temperature has
receded below 150°F (66°C), but the display and keypad
remain on.
Press the On/Off key to turn the oven on.
TURBOCHEF NGO
OVEN OFF
READY TO CLEAN
Figure 5: Oven Off
Cooking
The oven is preprogrammed with recipe settings at the time of manufacture and is ready to operate out of the
box. If these settings are erased, new menu settings must be either loaded via Oven Connect (page 4), smart
card (page 16), or programmed manually (pages 17-18).
The oven will not cook unless settings are present.
Note that the steps below are not always sequential. Typically, multiple items are cooked before cooling the
oven (Step 10).
Figure 6: Select Cook Temperature
Figure 7: Warming Up
TEMP 2: 350F
TEMP 1: 500F
SELECT COOK TEMPERATURE
WARMING UP
OVEN CC = 433F
OVEN SP = 500F
To Next Page
Loading...
Need help?
General
