INFO, TEST, AND EDIT MODE
17
Updating the Oven Firmware
CAUTION: The oven will be inoperable if
the firmware update is unsuccessful!
From the Oven Off screen,
1. Insert the gray smart card “1 of 3” (Figure 23,
page 16).
2. When the oven is cooling down or off, press
and hold the Info key until the oven resets
(approximately 5 seconds).
3. The oven will produce a series of short beeps.
When the oven beeps one long tone, insert
card “2 of 3.”
4. The oven will again produce a series of short
beeps. When the oven beeps one long tone,
insert card “3 of 3.”
5. The oven will again produce a series of short
beeps. When the oven beeps one long tone,
remove the smart card.
6. The oven will restart, indicating the update is
complete.
NOTE: If the update is unsuccessful, the display
will remain off and the oven will beep one long,
low tone. If the update fails multiple times, contact
TurboChef as a card may be damaged.
Menu Structure
The oven allows use of either one or two set tem-
peratures. Additionally, the SOTA can store up to
256 settings, while the SBK NGO can store 1,024.
See Figure 24 below for the differences.
Overview of the Edit Mode
NOTE: If your oven receives updates from Oven
Connect
TM
, then manually updating the menu is not
recommended.
To access the Edit Mode,
1. Enable it from the 1st Options Screen (Figure
14, page 12).
2. Press the On/Off key to return the oven to the
“Cooling Down” or “Off” screen.
3. Press the On/Off key again to enter Edit Mode.
The Edit Mode serves three main purposes:
1. Edit set temperatures
2. Edit names of food groups, items, and
“quantities”
3. Edit cook settings
Changing Set Temperatures
If a menu was loaded via Oven Connect
TM
or smart
card (page 16), the temperatures are already set and
do not need to be changed.
The set temperature should never be changed to
compensate for over-cooking or under-cooking.
If
recipe settings are not cooking as desired, consult
your menu developer, authorized distributor, or
TurboChef Customer Support.
To change a set temperature,
1. Place the oven in Edit Mode (above).
2. Press the L2 soft key to change temperature 1 or
L4 soft key to change temperature 2 (Figure 25).
3. Using the number keys, enter the new set
temperature.
4. Press the Enter key to confirm the change, or
the Back/Stop key to cancel.
Figure 25: Temperature Edit Screen
TEMP 2: 350F
TEMP 1: 500F
VALID RANGE BETWEEN 350F - 525F
EDIT temp 2 GROUPS
EDIT temp 1 GROUPS
R1
R2
R3
R4
L1
L2
L3
L4
SBK NGO SOTA
Type of card Gray White
Groups 16 (8/temp) 16 (8/temp)
Items per group 32 16
Quantities per item 2 N/A
Total # of settings 1,024 256
Figure 24: SBK NGO Versus SOTA Menus
To Next Page
Loading...
Need help?
General
