Page 62 of 66 Pages
Solution
12.1 A problem with the printer paper often prevents the operator from changing programs. To
rectify the problem, perform the following:
Turn off the main switch.
Remove the printer paper as described in the Chapter on “Printer Handling”.
At this point the no paper indicator on the printer lights.
Turn the main switch on. The cycle should return to the previous stage.
At this point insert the printer paper, verifying that it is inserted properly.
If the cycle does not return to its former stage, the technician will perform a memory reset.
After performing a reset, insert the printer paper with care.
If the above recommendations did not correct the malfunction, or if any problems not discussed in this section were
encountered, please contact an authorized technician.
Problem
12. You cannot
change the
program
and the
FAIL light
remains on.
If the
autoclave
with a
printer
POUCH RACK
To Next Page
Loading...
