Tyco CCU3/C-4100 - Page 23

23 of 35 REF: CCU3/C-4100.DOC REV: M September 26, 2005
Provide help on the computer port's keyword
commands
Example: HELP,CTIME <Enter>
Provide help for the CTIME command
LIST,[<point>],[<qual>] LIST,[<point>],[<qual>]
Returns the current logical point status for the point
requested
Example: LIST,P260 <Enter>
Return point status for point P260
LOGIN,[<password>] LOGIN,[<password>]
Log on of Log off
Example: LOGIN,XXXX <Enter>
Log on with password XXXX
PRINT,<arg> PRINT,<arg>
Print report to the system's report printer
Example: PRINT,ALOG <Example>
Send alarm log to currently selected printer
REV REV
Return a software revision string
Example: REV <Enter>
RST,[<qual>] RST,[<qual>]
Force the host panel to perform either a WARM or
COLD restart NOTE: Replaces RESTART command
Example: RST,COLD <Enter>
Perform a COLD start
SELECT,[1-5] SELECT,[1-5]
Select system report printer
Example: SEL,1 <Enter>
Select port 2 as the report printer
SET,<point>,<value> SET,<point>,<value>
Set point status
Example: SET,P5,ON <Enter>
Turn point P5 on
SHOW,[point>][<keyword>] SHOW,[point>][<keyword>]
Show point or system properties
Example: SHOW,ZN1 <Enter>
Show properties for point ZN1
SIL CTRL-S - Alarm Silence
SRS System reset.
TERMINAL,[<opt>],[<opt>],
[<opt>]
TERMINAL,[<opt>],[<opt>],[<opt>]
Set and display terminal flags
Example: TERMINAL,DEFAULT,ECHO <Enter>
Set DEFAUL and ECHO flags
TERMINAL <Enter>
Display set flags
TIME,[<time>] TIME,[<time>]
Set and display the time and date.