F4000 LCD Operator's Manual Document No: LT0117
Operating Instructions - Zone Functions
Page 7-12 19 April 2002 Issue 2.38
7.3.4 EXIT TEST
Press the "CLEAR" key once, to abort the test before the 30 second timer expires. The ACZ
will not be activated.
7.3.5 NOTES
(a) An attempt to test an already operated ACZ results in an error beep and no test is
initiated.
(b) It is possible to test only one ACZ at a time. (Note that one ACZ may include more
than one relay, depending on the number of relays mapped to that zone).
(d) An Ancillary Test cannot be started if there is an un-acknowledged alarm or fault
present; or if an Auto, System, Battery, Zone or Auto Reset Test is in progress.
To Next Page
Loading...
Need help?
General
