F4000 LCD Operator's Manual Document No: LT0117
Operating Instructions - System Functions
Page 6-18 19 April 2002 Issue 2.38
6.10 SET SYSTEM DATE
6.10.1 FUNCTION
Allows an operator to set the date in the real-time clock within the FIP.
6.10.2 OPERATING SEQUENCE
To set the date, press:
The current date is displayed. Enter the new date. To separate the day, month and year
numbers, press the "POINT" key.
E.g. To set the date to 14/07/93, press:
If the date is in the correct format and is a valid date, the FIP real time clock will be set to the
new date. The display reverts to the SET SYSTEM menu, so that other changes can be
made, if desired.
6.10.3 NOTES
On a network one panel may be set up as the time/date master. Setting the time or date at
this panel will result in the new time/date being sent to other panels on the network. The
time/date master will also send out the time/date to other panels at 11:30pm each day and
on daylight saving changes.