Document No: LT0117 F4000 LCD Operator's Manual
Introduction
Issue 2.38 19 April 2002 Page 1-3
SCOPE (CONTINUED)
Chapter 9: Placing Into Operation; A description of how to place a correctly aligned
and adjusted system into operation. Also included is a System
Commissioning Checklist.
Chapter 10: Maintenance and Trouble-Shooting; A guide on system maintenance
procedures and trouble-shooting.
Appendix A: Responder Compatible Actuating Devices; A list of compatible actuating
devices and detectors for the F4000 FIP.
Appendix B: Compatible Batteries; A list of compatible batteries.
Appendix C: FFCIF Type 2 Fire Fighters Guide; For use when the FIP is programmed for
FFCIF Type 2 operation.
1.2 ATTACHMENTS
A FIRE FIGHTER'S GUIDE is fixed inside the front cover for quick reference in
emergencies.
If the F4000 FFCIF is configured for Type 2 operation, i.e. global acknowledgement, reset
and isolation of zones in alarm, refer to Appendix C for instructions on ensuring that the
correct Fire Fighters Guide is used.
Your installation company should install the following documents inside the panel:
(a) An "AS INSTALLED" fire detection system diagram and/or summary, describing the
installed layout of your F4000 System.
(b) Other "AS INSTALLED" information, such as System configuration parameters.
(c) A Maintenance Log-Book.
To Next Page
Loading...
Need help?
General
