EasyManuals Logo

Tyco F4000 User Manual

Tyco F4000
162 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #110 background imageLoading...
Page #110 background image
F4000 LCD Operator's Manual Document No: LT0117
Operating Instructions - Zone Functions
Page 7-14 19 April 2002 Issue 2.38
7.4.3 OPERATING SEQUENCE - ZONE RANGE
From the base display, press:
to reset zone numbers n n n to m m m. This command can also be used on networked
zones - refer to Section 2.5.1 for network zone number entry.
For networked zones the LCD will display the network zones with a message saying
"Network Command Sent". After a brief period the message should change to "Network
Command Accepted".
Refer to Section 2.5.6 for more details on these and other possible LCD display messages.
If an exception occurs at the remote FIP, then an exception display may be received
indicating the type of exception. Refer to Section 2.5.7 for a discussion of Exception
Messages.
IMPORTANT The range of zones entered at an F4000 must be limited to zones on a single
networked FIP, i.e. the range cannot encompass zones on more than one
FIP.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Tyco F4000 and is the answer not in the manual?

Tyco F4000 Specifications

General IconGeneral
BrandTyco
ModelF4000
CategoryFire Alarms
LanguageEnglish

Related product manuals