Document No: LT0117 F4000 LCD Operator's Manual
Operating Instructions - Point Functions
Issue 2.38 19 April 2002 Page 8-17
8.4.3 NOTES
(1) The LCD will immediately display a "Responder type cannot isolate points" message
if the point is on a responder NOT configured for point isolation. The LCD will display
a "Responder ignored isolate/de-isolate cmd" message if an isolate/de-isolate
command is not confirmed (usually due to misconfiguration of the system).
(2) Point Isolation status is stored in the MPR's database, and may be lost if the MPR is
powered down for a long period. If this happens, all points become de-isolated.
To Next Page
Loading...
Need help?
General
