F4000 LCD Operator's Manual Document No: LT0117
System Description
Page 2-26 19 April 2002 Issue 2.38
2.5.7.3 F4000 EXCEPTION EXAMPLES
Network F4000s are able to generate the following exception messages:
"Not All Zones De-Isolated"
The zone range de-isolation command processed did not de-isolate one or more
zones because they were in alarm or fault.
"Zxxxxx Test Passed"
"Zxxxxx Test Failed"
"Zxxxxx Test Aborted"
"Zxxxxx Test Time Out"
The previous Zone test command issued to zone xxxxx had the noted result.
"System Test Passed"
"System Test Failed"
"System Test Aborted"
The previous System test command had the noted result.
"Battery Test Passed"
"Battery Test Failed"
"Battery Test Aborted"
The previous Battery test command had the noted result
2.5.8 NETWORK F4000 LCD DISPLAYS
A network F4000 may be programmed to display either its own off-normal totals or a
combination of its own totals and the off-normal totals of other devices on the network.
Consequently, some totals may exceed the maximum totals expected for a single F4000
panel.
If there are no off-normals, the "base" display of the F4000 LCD displays the system name,
date and time, and F4000 software version. The software version text can be replaced by
text that indicates the operational state of the F4000, eg. testing, no processing, etc.
The number of texts that can be shown has been increased to handle the cases where tests
have been started by operators at other panels on the network. The texts are:
"F4000 V2.3xN" V2.3xN Default text.
"AUTOMATIC TESTING" An automatic daily test is running.
"SYSTEM TESTING" A remotely initiated system test is running.
"BATTERY TESTING" A remotely initiated battery test or NZ 1 hour battery test is
running.
"ACZ TESTING" A remotely initiated ACZ test is running.
"ZONE TESTING" A remotely initiated Zone test is running.
The Fault Action text will still override the above texts if the fault buzzer turns on.
To Next Page
Loading...
Need help?
General
