EasyManua.ls Logo

Uconnect 8.4 - Page 72

Uconnect 8.4
210 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
interference that may cause undesired operation. Modifi-
cations not expressly approved by the radio manufacturer
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursu-
ant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interfer-
ence in an installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harm-
ful interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harm-
ful interference to radio or television reception, which can
be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one
or more of the following measures:
Increase the separation between the equipment and
receiver.
Consult the dealer or an experienced radio technician for
help.
Safety Information
Exposure to Radio Frequency Radiation
The radiated output power of the internal wireless radio is
far below the FCC radio frequency exposure limits. Nev-
ertheless, the wireless radio shall be used in such a manner
that the radio is 8 inches (20 cm) or further from the human
body.
The internal wireless radio operates within guidelines
found in radio frequency safety standards and recommen-
dations, which reflect the consensus of the scientific com-
munity. The radio manufacturer believes the internal wire-
less radio is safe for use by consumers. The level of energy
emitted is far less than the electromagnetic energy emitted
by wireless devices such as mobile devices.
DEVICE CONNECTION AND AUDIO TIPS WITH
UCONNECT
More than one device can be paired to your vehicle. The
connected device with the highest priority will be used.
To transition between devices, Select Phone > Settings,
then press the desired device.
Multiple devices may be connected at one time. For
example, a device can be paired and connected for
hands-free calling and texting, while a USB media
source is connected for audio. However, only one
Bluetooth connection can be used at a time.
3
ALL ABOUT UCONNECT ACCESS 71

Table of Contents

Other manuals for Uconnect 8.4

Related product manuals