5.1. Sine wave
Click the “Sine” button for a sine wave. At this time, you can set the parameters for the sine waveform.
Click the parameter or rotate the Rotary-3 to select it to be adjusted. An upper parameter is selected when
the Rotary-3 is rotated clockwise, and a lower parameter is selected when rotated counterclockwise. The
selected parameter is marked with a light blue color. Which digit of the parameter is desired to be set is
selected with Rotary-2. The selected digit moves to the right when the Rotary-2 is rotated clockwise, and to
the left when it is turned counterclockwise. After the digit is selected, the parameter setting is made by
turning Rotary-1. When it is rotated clockwise, the parameter increases by the value of the selected digit
(for example, if the tens digit is selected, the parameter setting is adjusted in ten steps). If it is rotated
counterclockwise, the parameter value is decreased.
Digit selection and parameter setting can also be adjusted with the scroll button of the mouse, as an
alternative to the one described above. Clicking the scroll button switches between parameter setting and
digit setting. When the scroll is rotated, the selected digit or parameter is set.
Frequency setting:
“Frequency” parameter is set for frequency setting. In the sine wave, the frequency can be adjusted
between 1 mHz and 20 MHz.
Amplitude setting:
The “Amplitude” parameter is set for the amplitude setting. The amplitude can be adjusted between 0V
and 10V (if the offset is 0V).
Offset setting:
“Offset” parameter is set for offset setting. The offset can be adjusted between -5V and +5V (if the
amplitude is 0V).
To Next Page
Loading...
Need help?
General