10. PC Program
Control of three modes of UCE-DSO4200C can be done with PC program (PC_DSO4200.exe). There are
vertically arranged tabs on the left side of the screen (Figure 16).
• Oscilloscope,
• Signal Generator,
• Curve Tracer,
• About.
Figure 16. PC program (Oscilloscope menu active)
In this section, the use of the PC program will be briefly discussed. The functions are explained in detail in
the device usage.
10.1. Oscilloscope menu
Click the “Oscilloscope” tab on the left to open the oscilloscope menu.
To Next Page
Loading...
