• Max input voltage: ±50V (X1 Probe), ±500V (X10 Probe)
• Coupling: AC/DC
• XY Mode
• Trig modes: Run, single, hold functions
• Trigger functions: rising / falling edge
• Auto Measurement: frequency, peak-to-peak voltage, mean voltage, RMS voltage
• Cursor: differential measurement for time and voltage
• FFT analyze: 1024 points FFT analyze
• Math Functions: CH1+CH2, CH1-CH2, CH1*CH2, CH1/CH2, CH1 FFT, CH2 FFT.
Features of Signal Generator:
• Signals: Sine, square, triangle, sawtooth, sinC, noise, exponential, full wave, half wave, gauss,
direct, staircase.
• Max. Voltage: ±5.0V (10Vpp)
• Frequency: 0.001Hz 20MHz
Features of Curve Tracer:
• Waveform: Sine wave
• Test Frequencies: 20Hz 10kHz (36 steps)
• Open circuit Voltage: ±0.2V ±20V (24 steps)
• Source Resistance: 10Ω, 47Ω, 100Ω, 470Ω, 1kΩ, 4.7kΩ, 10kΩ
• 5 programmable user buttons
Package List:
• Carrying Case
• UCE-DSO4200C Device
• Multi-Device Wireless Mouse
• 2 sets 4mm banana multimeter probes
• 2 pcs X1, X10 Oscilloscope Probe
• 1 pc Test Hook Clip Probe for Signal Generator
• 12V 2A power supply (EU Type)
• Touch pen
• USB cable
• HDMI cable
To Next Page
Loading...
Need help?
General