ULEAD DVD MOVIEFACTORY USER GUIDE 11
Analog capture card
To check the setup of DVD MovieFactory for analog
interface:
1. Connect your camcorder, VCR, or other video source device to
your analog capture card.
2. Insert your video tape into the capture device and switch it on.
Make sure it is in the playback mode (usually named VTR or
VCR). See your machine’s manual for specific instructions.
3. Your Capture plug-in will be detected automatically.
4. Go to the Add/Edit Media page and click Capture Video to
open the Capture Video dialog box.
5. Check if your device is displayed under Source.
USB input device
To check the setup of DVD MovieFactory for USB
interface:
1. Connect your video source device to your USB port using a
standard USB cable and switch it on.
2. Your Capture plug-in will automatically be detected.
3. Go to Add/Edit Media and click Capture Video to open the
Capture Video dialog box.
4. Check if your device is displayed under Source.
Note: If your capture device supports multiple video sources, the
Video and Audio Capture Property Settings dialog box allows
you to select your desired video source such as Composite, Tuner, or
S-Video. In the Capture Video dialog box, click Advanced Settings
and select Video and Audio Capture Property Settings from the
pop-up menu.
Likewise, if you have multiple audio sources, this dialog box allows
you to select your desired audio source.
To Next Page
Loading...