ULEAD DVD MOVIEFACTORY USER GUIDE 23
3. Select your analog device from the Source list.
4. Select a capture file format from the Format list.
5. Click Show/Hide to show the advanced settings. Next, click
Advanced Settings: Video and Audio Capture Property
Settings. Here, choose the correct TV system, video and audio
sources. Click OK to apply the settings.
6. Click Advanced Settings: Change Field Order to set the
appropriate field order.
7. Scan your video using your hardware’s preview buttons to
search the part you want to capture.
8. When you get to the point where you want to start capturing,
click Capture Video. Click Stop Capture or press [Esc] to stop
capturing.
Capturing TV footage
DVD MovieFactory allows you to capture TV footage with a TV
tuner. Capture a segment of your favorite television show on
regular TV or cable then save it in your hard drive in AVI, MPEG, or
Windows Media Video (WMV) format.
To capture TV footage:
1. Check if your computer has an analog video capture card with a
TV input jack. This jack usually uses a TV coaxial cable to input
TV signals from either an antenna or a dedicated cable from your
CATV supplier.
2. Connect your video source device to your capture card. On some
cards, you may need to connect the audio cables.
3. In the Add/Edit Media page, click Capture Video.
4. Select your analog device from the Source list.
5. Select the appropriate Capture mode and then enter the TV
channel number of the program to capture.
6. Select the appropriate video format from the Format list.
7. Click Capture Video to start capturing.
8. Click Stop Capture or press [Esc] to stop capturing.
To Next Page
Loading...