16 GETTING STARTED Customer Service: 888-269-7477
Example 2: If there is not an available Ethernet jack in your DSL or cable
modem, you will need a router or switch that lets you connect more than
one device to the Internet. Contact your Internet Service Provider to learn
what router or switch will work with your modem. The router should
support DHCP. Connect the router to your DSL/cable modem. Then connect
the CapTel 2400iBT to the router or switch using the Ethernet cable.
If your Internet outlet is in a di erent room from where you plan to use
CapTel, see the Setup Guide for instructions.
Power
Outlet
Telephone
Wall Outlet
Router
DSL or Digital
Cable Modem
Power Cord
Telephone Line
Ethernet Cable
Back of CapTel 2400iBT
Telephone
Ethernet
Power
LNK/ACT
Power
Outlet
Telephone
Wall Outlet
DSL or Digital
Cable Modem
Power Cord
Telephone Line
Ethernet Cable
Back of CapTel 2400iBT
Telephone
Ethernet
Power
LNK/ACT
All outlets located together (Wired Setup)
Example 1: All of the connection outlets (telephone, Internet, and power) are
available in the same room that you are planning to use the CapTel 2400iBT.
NOTE
To Next Page
Loading...
