1ST SERVICE/RUNNING IN
NOTE
Engine/trans.
Cycle
Electrical
ENGINE OIL: Change (warm up the engine before draining)
OIL FILTER: Change
WHEELS: Check the correct tension of the spokes
FINAL CHECK: Carry out an on-road test drive, paying attention to the general
operation of the brakes, steering, clutch, suspensions, engine, lights and instru-
ment panel indicator lights.
SYSTEM
INSPECTION TYPE 1
NOTE
Engine/trans.
Cycle
Electrical
General
ENGINE OIL: Change (warm up the engine before draining)
OIL FILTER: Change
SPARK PLUG: Check the gap between the electrodes - Adjust if necessary
SECONDARY TRANSMISSION: Check the chain tension - Adjust if necessary
SECONDARY TRANSMISSION: Check the wear of the sprocket and plate
SECONDARY TRANSMISSION: Check the wear on the roller and chain guides -
Change if necessary
COOLANT: Check the level – Top up if necessary
BRAKE PADS: Check the wear – Renew if necessary
BRAKE LEVER CABLES: Check condition
BRAKE LEVERS AND THROTTLE TWIST GRIP: Check the correct operation
and free play
WHEELS: Check the correct tension of the spokes
BRAKE FLUID: Check the level – Top up if necessary
FUEL PIPES: Check for possible cracks
Check for possible fluid leaks (petrol, oil, coolant, brake fluid)
ELECTRIC FAN: Check operation
FRONT HEADLIGHT: Adjust the beam height
BATTERY: Check state of charge – Charge if necessary
CONTROL ELEMENTS: Check the correct operation
LIGHTS: Check the operation of the mechanisms and the correct functioning of the
bulbs/LEDs
HORN: Check its correct operation
FINAL CHECK: Carry out an on-road test drive, paying attention to the general
operation of the brakes, steering, clutch, suspensions, engine, lights and instru-
ment panel lights.
SYSTEM
Note 2
Note 2
25
REGULAR INSPECTION
AND ADJUSTMENTS
WORKSHOP MANUAL
To Next Page
Loading...
Need help?
General
