UPO2000CS series User Manua
17
and deep storage.
STORAGE: Storage interface can select different types of storage and waveform settings, which can be stored
internally or through USB device.
CURSOR: Cursor measurement menu can measure waveform’s time and voltage manually with cursor.
DISPLAY: Select display settings, such as display type, format, duration, grid brightness, and waveform
brightness.
UTILITY: The utility menu can choose between some less commonly used settings such as self-calibration,
system information, language, menu display, waveform recording, pass test, square wave output, frequency
meter, system upgrades, backlight brightness, output, etc.
DEFAULT: Restore to factory default settings.
1.6 User Interface
①. USB Device Identification: This icon will be displayed when an USB storage device is connected.
②. Trigger Status Identification: Include TRIGED (has been triggered), AUTO, READY, STOP, and ROLL
(rolling)
③. Timing Scale: Indicates the amount of time represented by one square, which can be adjusted by the
horizontal scale knob.
④. Sampling Rate/Acquisition Mode: Indicates the current sampling rate and storage depth.
⑤. Horizontal Displacement: Shows the horizontal displacement, which can be adjusted by turning the
To Next Page
Loading...
