EasyManua.ls Logo

UNI-T UPO2000CS Series

UNI-T UPO2000CS Series
94 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
UPO2000CS series User Manual
66
Vpp: Vmax Vmin
Vamp: Vtop Vbase
Mean: Average amplitude of the waveform on screen
CycMean: Average amplitude of a waveform in one period
RMS: The effective value. According to the energy produced by the AC signal in the conversion, the
equivalent energy that the DC voltage corresponds to
CycRMS: The RMS of one period
Overshoot: The ratio of the difference between Vmax and Vtop
Preshoot: The ratio of the difference between Vmin and Vbase
Area: The product of time and voltage for all points on the screen
CycArea: The product of time and voltage for all points in one period
8.3 Timing Parameters
Timing Parameter
Period: The duration of one cycle of a repetitive waveform
Frequency: The reciprocal of the period
Rise time: The time it takes the waveform amplitude to increase from 10% to 90%
Fall time: The time it takes the waveform amplitude to decrease from 90% to 10%
+Width: The width of a positive pulse at 50% amplitude
-Width: The width of a negative pulse at 50% amplitude
+Duty: The ratio of positive pulse width to period
-Duty: The ratio of negative pulse width to period
8.4 Delay Parameters
FRR: Time between the first rising edge of source 1 to the first rising edge of source 2
FRF: Time between the first rising edge of source 1 to the first falling edge of source 2
FFR: Time between the first falling edge of source 1 to the first rising edge of source 2
FFF: Time between the first falling edge of source 1 to the first falling edge of source 2
LRF: Time between the last rising edge of source 1 to the last falling edge of source 2

Table of Contents

Related product manuals