UNI-T UPO2000CS Series User Manual

UPO2000CS series User Manua
71
Chapter 10 Storage and Callback
With the storage function, you can save the oscilloscope's settings, waveforms, and screen imagees to the
oscilloscope's internal or external USB storage devices, and recall the saved settings or waveforms anytime. Press
the STORAGE key to enter the storage function setting interface.
UPO2000CS series oscilloscope supports FAT format USB storage devices. It is not compatible with NTFS format.
10.1 Storage Setting and Callback
Press STORAGE button, then press F1 to select the type to settings to enter the storage settings menu.
Functions Options Descriptions
Type
Storage
Setting
Disk
DSO Data will be saved on the oscilloscope
USB Data will be saved on USB drive
Filename
Filename can be chosen with the multipurpose knob. Names can be
chosen from set001, set002, …., set225
Save Saves settings to selected disk
Callback
Call back previously saved settings, returns the oscilloscope to the
previously saved setting state
Remarks
 Oscilloscope can only select USB device when U disk or other external storage devices are plugged in.
 Callback only works when previously saved disk and the file name are consistent, or else it will fail to load.
10.2 Waveform Storage and Callback
Press the STORAGE button, then press F1 to set the type as waveform to go into waveform storage menu.
Functions Options Descriptions
Type Waveform Storage
Source
CH1, CH2, CH3,
CH4
Select waveform storage source from any one of CH1~CH4
Disk
DSO
When Save is pressed, waveform will be saved to the
oscilloscope
USB
When Save is pressed, waveform will be saved to external USB
device

UNI-T UPO2000CS Series Specifications

General

Brand	UNI-T
Model	UPO2000CS Series
Category	Test Equipment
Language	English