Open the D-value measurement statistics after defining parameter
Chapter 9 - Cursor Measurement
The cursor can be used to measure the X axis (time) and the Y axis
(voltage) of the selected waveform. Press the CURSOR button to enter
the cursor measurement menu.
9.1 Time Measurement
Press the CURSOR key to enter the cursor measurement menu, then press
F1 to select the type to time.
• Press F2 to set the pattern to independent.
• The Multipurpose knob can adjust the vertical cursor AX, press the
multipurpose knob to switch to cursor BX.
The measured values are shown in the upper left corner of the waveform
display area. The value of BX-AX is the time measurement, and 1/|BX-AX|
is the reciprocal of time.
For a periodic signal, if AX and BX are set at the rising edge of adjacent
cycles, then BX-AX is the signal’s period, and 1/|BX-AX| is the frequency.
The voltage value can also be displayed at cursor’s current position. That
is AY, BY, and BY-AY.The Multipurpose knob can be used to adjust the BX
and AX positions when setting is set to trace mode with using the F2 key.
9.2 Voltage Measurement
• The method for voltage measurement is similar to the method for time
measurement, only that the vertical cursor becomes the horizontal cursor.
• Press the CURSOR key to enter the cursor measurement menu, then
press F1 to select the type as voltage.
• Press F2 to set the pattern to independent
The Multipurpose knob can be used to adjust the horizontal cursor AY on
the screen, press the Multipurpose knob to switch to cursor BY. The value
of BY-AY is the voltage measurement (V). When the setting is set to trace
mode with using the F2 key, the Multipurpose knob can adjust both AY and
BY at the same time.
UTD2000CEX-II User Manual
To Next Page
Loading...
