After the waveform is saved, you can use the REF key for callback. Press
the REF key to enter the waveform callback menu.
Waveform Callback Menu
Descriptions
When Save key is pressed, waveform
will be saved to the oscilloscope
When Save key is pressed, waveform
will be saved to external USB device
Callback previously saved
waveform and display on screen
Close current REF waveform
Options
RefA、RefB
DSO
USB
Functions
Type
Disk
Callback
Clear
After callback, the Ref waveform will be displayed in the lower left corner,
including timing scale and amplitude shift. At this point you can use the
vertical and horizontal control knob to adjust the ref waveform’s position,
time base, and amplitude shift.
10.3 Screen Copy
The PrtSc key can be used to store the current screen in BMP format to
an external USB storage device. The bitmap can be opened directly on
the PC. This function can only be used when external USB storage devices
are connected.
Chapter 11- Auxiliary Function Setting
Press the UTILITY key to enter the auxiliary function settings menu.
Auxiliary function setting menu (1)
Descriptions
Enter system configuration page
Enter interface configuration page
Enter pass test page
Enter wave record page
Enters Auxiliary function setting menu (2)
Functions
System configuration
Interface configuration
Pass test
Wave record
1/3
Options
Auxiliary function settings menu (2)
Descriptions
Enter AUTO strategy page
Enters Auxiliary function setting menu (3)
Functions
Measurement unit
AUTO strategy
2/3
Options
V/A
Note: The frequency meter is a counter for trigger events. The frequency
meter is valid for edge or pulse width, but is not valid for the other trigger
type .
Auxiliary function settings menu (3)
Descriptions
Enter recorder page
Enter waveform generator page
Set up frequency of reference
waveform
Enter oscilloscope software
update page
1Hz/10Hz/100Hz/
1kHz/10kHz/100kHz
Functions
Recorder
waveform generator
Square wave output
System Upgrade
Options
UTD2000CEX-II User Manual
To Next Page
Loading...
