UNI-T UTG900E Series

Programming Manual UTG900E Series
Instruments.uni-trend.com
20 / 41
:CHANnel1:FSK:HOPP:FREQ?
The query returns 2e+3
:CHANnel<n>:SWEep:FREQuency:STARt
 Command Format
:CHANnel<n>:SWEep:FREQuency:STARt <freq>
:CHANnel<n>:SWEep:FREQuency:STARt?
 Function
Set the start frequency of sweep in specified channel.
< freq > means frequency, in “Hz” unit.
<n>: Channel No., n value 1, 2.
 Return Format
The query returns the start frequency of sweep in specified channel, using scientific notation to return
the data.
 Example
:CHANnel1:SWE:FREQ:STAR 2000
Set the start frequency of sweep in channel 1 to 2KHz
:CHANnel1:SWE:FREQ:STAR?
The query returns 2e+3
:CHANnel<n>:SWEep:FREQuency:STOP
 Command Format
:CHANnel<n>:SWEep:FREQuency:STOP <freq>
:CHANnel<n>:SWEep:FREQuency:STOP?
 Function
Set the stop frequency of sweep in specified channel.
< freq > means frequency, in “Hz” unit.
<n>: Channel No., n value 1, 2.
 Return Format
The query returns the stop frequency of sweep in specified channel, using scientific notation to return
the data.
 Example
:CHANnel1:SWE:FREQ:STOP 2000
Set the stop frequency of sweep in channel 1 to 2KHz
:CHANnel1:SWE:FREQ:STOP?
The query returns 2e+3
:CHANnel<n>:SWEep:TIMe
 Command Format
:CHANnel<n>:SWEEP:TIMe { <time>}
:CHANnel<n>:SWEEP:TIMe?
 Function
Set the sweep time of specified channel.
< time > means time, in “S” unit, range of 1ms ~ 500s.
<n>: Channel No., n value 1, 2.
 Return Format
The query returns the sweep time of specified channel, using scientific notation to return the data.