Programming Manual UTG900E Series
Instruments.uni-trend.com
Programming Instructions
Describe some troubles and solutions during the programming operation, and please follow instructions if
any trouble met.
Programming Preparation
The programming preparation is only for the Visual Studio and LabVIEW programming in the Windows
operating system.
Make sure that your computer has been installed VISA library of NI (Download in
https://www.ni.com/en-ca/support/downloads/drivers/download.ni-visa.html), and the default installation
path in this page: C:\Program Files\IVI Foundation\VISA.
Establishing communication with PC, please use USB cable to connect the USB DEVICE interface of device
with the USB interface of PC.
To Next Page
Loading...
