UNI-T UTG900E Series Programming Manual

Programming Manual UTG900E Series
Instruments.uni-trend.com
5 / 41
SCPI Details
IEEE488.2 Common Commands
*IDN?
 Command Format
*IDN?
 Function
Query the manufacturer name, signal source model, product serial number and software versioning.
 Return Format
The query returns the manufacturer name, signal source model, product serial number and the
software versioning separated by dot.
Note: The returning model should be same as the nameplate.
 Example
UNI-T Technologies, UTG900, 000000001, 00.00.01
*RST
 Command Format
*RST
 Function
Restore factory settings, clear all error messages and send/receive queue buffers.
SYSTem Commands
It is used for the most basic operation of signal source, mainly including the operation of full keyboard lock
and the system data setting.
:SYSTem:LOCK
 Command Format
:SYSTem:LOCK {{1 | ON} | {0 | OFF}}
:SYSTem:LOCK?
 Function
Lock or unlock the full keyboard keys and touch input.
 Return Format
The query returns the full keyboard status, and 0 in UNLOCK, 1 in LOCK.
 Example
:SYSTem:LOCK ON Full keyboard LOCK
:SYSTem:LOCK OFF Full keyboard UNLOCK
:SYSTem:LOCK? Query returns 1, LOCK
:SYSTem:CONFigure
 Command Format
:SYSTem:CONFigure <file>
:SYSTem:CONFigure?
 Function
Read and write the configuration file, sending commands first, and send configuration file data to the
signal source.

UNI-T UTG900E Series Specifications

General

Brand	UNI-T
Model	UTG900E Series
Category	Portable Generator
Language	English