UNI-T UTG900E Series - Chapter 2 Introduction; 2.1 Main Feature; 2.2 Output Features

Programming Manual UTG900E Series
Instruments.uni-trend.com
6 / 41
<file> means the configuration file.
 Return Format
The query returns the current configuration file data of signal source.
 Example
:SYSTem:CONFigure
Write the configuration file data into signal source and load it.
:SYSTem:CONFigure?
The query returns a binary stream of current configuration file data of signal source.
:SYSTem:PHASe:MODe
 Command Format
:SYSTem:PHASe:MODe {INDependent | SYNChronization}
:SYSTem:PHASe:MODe?
 Function
Control the phase mode between channels. The starting phases of two channels are synchronized if it
is synchronous, otherwise independent.
 Return Format
The query returns the phase mode between channels.
 Example
:SYSTem:PHASe:MODe INDependent
Set the independent phase mode between channels.
:SYSTem:PHASe:MODe?
The query returns INDependent.
:SYSTem:LANGuage
 Command Format
:SYSTem:LANGuage {ENGLish|CHINese}
:SYSTem:LANGuage?
 Function
Control the system language.
 Return Format
The query returns system languages.
 Example
:SYSTem:LANGuage ENGLish
Set the system language to English.
:SYSTem:LANGuage?
The query returns ENGLish.
:SYSTem:BEEP
 Command Format
:SYSTem:BEEP {{1 | ON} | {0 | OFF}}
:SYSTem:BEEP?
 Function
Control the buzzer of system.
 Return Format
The query returns the buzzer ON/OFF status.
 Example