UNI-T UTG900E Series - CHANnel Commands; :CHANneln:OUTPut; :CHANneln:INVersion; :CHANneln:OUTPut:SYNC

Programming Manual UTG900E Series
Instruments.uni-trend.com
9 / 41
CHANnel Commands
Set the related functions of signal source channels.
:CHANnel<n>:OUTPut
 Command Format
:CHANnel<n>:OUTPut {{1 | ON} | {0 | OFF}}
:CHANnel<n>:OUTPut?
 Function
Set the specified channel output ON/OFF.
<n>：Channel No., n value 1, 2.
 Return Format
The query returns the specified channel output status, 0 in OFF, 1 in ON.
 Example
:CHANnel1:OUTPut ON Set the channel 1 output ON
:CHANnel1:OUTPut? The query returns 1
:CHANnel<n>:INVersion
 Command Format
:CHANnel<n>:INVersion {{1 | ON} | {0 | OFF}}
:CHANnel<n>:INVersion?
 Function
Set the specified channel reverse ON/OFF.
<n>：Channel No., n value 1, 2.
 Return Format
The query returns the specified channel reverse, 0 in OFF, 1 in ON.
 Example
:CHANnel1:INVersion ON
Set the reverse output of channel 1 ON
:CHANnel1:INVersion?
The query returns 1
:CHANnel<n>:OUTPut:SYNC
 Command Format
:CHANnel<n>:OUTPut:SYNC {{1 | ON} | {0 | OFF}}
:CHANnel<n>:OUTPut:SYNC?
 Function
Set the sync output of channel.
Note: Only one sync output interface in the device, and can only open the sync output of one channel.
<n>: Channel No., n value 1, 2.
 Return Format
The query returns the sync output of specified channel, 0 in OFF, 1 in ON.
 Example
:CHANnel1:OUTPut:SYNC ON
Set the sync output of channel 1 ON
:CHANnel1:OUTPut:SYNC?