Unify OpenScape Cordless IP V2 Service Documentation

c05.fm
Configuration Hints for PBXs
OpenScape Voice (OSV) V9
A31003-C1020-S100-03-7620, 12/2017
OpenScape Cordless IP V2, Service Documentation 71
Save the modifications by clicking [Set].
5.3 OpenScape Voice (OSV) V9
This chapter contains configuration hints to configure an OpenScape Voice for
usage with an OpenScape Cordless IP V2 system using SIP subscribers.
5.3.1 General - OSV
There are 2 different setups for usage of OpenScape Cordless IP V2 connected
to OpenScape Voice (OSV).
OpenScape Cordless IP V2 is connected to OpenScape Voice directly:
OpenScape Cordless IP V2 is able to communicate with one OpenScapeVoice-
SIP-address only. In case of geographically separated OSV-cluster the nodes
have different Signaling-IP-addresses in different IP-subnets. Therefore
OpenScape Cordless IP V2 Users can only be connected to OSV-Node1 or to
OSV-Node2. If this node will fail no communication via OpenScape Cordless IP
V2 would be possible anymore.
This problem does not exist if OpenScape Cordless IP V2 is connected to a co-
located OSV-cluster until 2nd OSV will take over the Signaling-address of the 1st
node in case of node-failure.
Entry Value(example)
Authentication name 152500
Authentication password 152500
Username: 15250
Display name: 15250
VoIP Provider: ST15

Unify OpenScape Cordless IP V2 Specifications

General

Brand	Unify
Model	OpenScape Cordless IP V2
Category	Accessories
Language	English