Unify OpenScape Cordless IP V2 Service Documentation

Diagnosis and Maintenance
c07.fm
Troubleshooting
A31003-C1020-S100-03-7620, 12/2017
96 OpenScape Cordless IP V2, Service Documentation
7.3.2 What Happens If ...
7.3.2.1 Synchronism Symbol on Handset Display:
–"Base n"
flashes
No synchronization to base station
1. Is the mobile telephone not logged on?
2. If the mobile telephone is logged on to multiple
systems, is it switched to the correct system? Is
automatic system selection activated?
Check the base station.
–"Base n"
continuously visible
but no action is
possible
Synchronization to base station
1. An error tone can be heard when the line key is
pressed.
Temporary overload status (all the base station
speech paths are busy).
Wait, and try again.
2. Handset was not able to complete the locations
request successfully (handset contact to the
system).
Workaround:
Repeat locations request by switching off the
handset and then switching it on again.

Unify OpenScape Cordless IP V2 Specifications

General

Brand	Unify
Model	OpenScape Cordless IP V2
Category	Accessories
Language	English