Unify OpenScape Cordless IP V2 Service Documentation

c07.fm
Diagnosis and Maintenance
Troubleshooting
A31003-C1020-S100-03-7620, 12/2017
OpenScape Cordless IP V2, Service Documentation 95
7.3 Troubleshooting
7.3.1 Checking OpenScape Cordless IP Components
• Entire system
– Set up call with the
mobile telephone
Operating Manual
Subjective evaluation of voice connection, for example,
background noise
• Check the radio area
coverage
See Section 7.1.2
(range warning tone activated)
• DECT IP Base station
(BSIP1)
– LED 1/2 See Chapter 6
– Base station status PC
– Check active status of
base station using the
logged-on mobile
telephone
No synchronism:
"Base n" blinks on handset display.
Handset measuring mode is activated:
- Frequency/slot changes
- RSSI value
If this is not the case, perform the test on a different base
station.
If it is still unsuccessful, use a different handset.
If it is still not possible to synchronize with a base station
after repeated attempts, replace the base station.
• Mobile telephone (MT)
– Logged-on mobile
telephone, synchronized
with base station
Synchronism symbol "Base n" (name = individual
setting) on handset display is continuously visible, does
not blink.

Unify OpenScape Cordless IP V2 Specifications

General

Brand	Unify
Model	OpenScape Cordless IP V2
Category	Accessories
Language	English